GI Screw Hook No.10 - Pack of 10

Ceramic Coating. Resists Heat Up To 2,000°F. Gas & Oil Resistant. No Peel Promise. Adhesion Guarantee. Stops Rust Formula.

It is used to protect and route of electrical wiring in a building or structure.

Noise Reduction.

Ergonomics.

Surface Protection.

Better Towing Capabilities.

Long life.

Ideal for filling cracks, holes, leveling uneven surfaces and perfect for modeling.

Suitable for stone, plaster and concrete.

For indoor use only.

White Cement is the preferred for smooth exterior/interior walls and ceilings, mosaic tiles, terrazzo flooring.

Type of order : Toggle

Neutral position : without neutral

Number of poles : 3 P

Type of pole : 3 P

Main electrical features

Frequency : 50/60 Hz

Rated operational voltage Ue : 415 V

Voltage

Rated insulation voltage : 440 V

Rated impulse withstand voltage : 6000 V

Electric current

Rated operational current in AC21 category A : 63 A

Rated operational current in AC21category B : 63 A

Acceptable current rating with AC22 category A : 63 A

Acceptable current rating with AC22 category B : 63 A

Closing ability with 400V in AC23A : 1332 A

Rated short-circuit making capacity Icm under 415V AC according IEC 60947-3 : 1332 A

Rated short-time withstand current 1s : 0,945 kA

Thermal rated current outside of housings : 63 A

Power

Power loss per pole at In : 3,5 W

Total power loss under IN : 10,4 W

Instant Grab (No Support Required).

High Strength Bonding.

Does Not Attack Mirror Coating.

Low VOC and Environmentally Friendly.

National Spray Plaster Fine is recommended for leveling and smoothening the internal ceilings or walls for the subsequent finish coat systems to get the maximum performances. It can be applied as an undercoat on location ground floor, basement or any upper deck of car park concrete walls and ceilings. It is also used as an economical decorative spray texture on ceilings and be over coated with recommended topcoat. 

• Widely used as an expansion joint by water proofing companies.

• Noise protection filler for aluminium extrusion.

• Used as filler for decoration purpose.

• Lightweight fill for aluminium extrusions.

Application: Indoor and outdoor.

Tools: brush or spray gun.

Dilution: ready to use.

For spray gun: dilute with ± 10% of white-spirit.

Drying time: 14 Recoatable: ±24 hours.

This is a paint thinner. Designed to improve the flow of a range of Jotun polyurethane products. Can also be used as cleaner for pumps and tools before and after painting.