The product can be applied by :

Roller : Recommended.

Spray : Use airless spray or conventional spray.

Use airless spray or conventional spray.



Conditions during application :

The temperature of the substrate should be minimum 10 °C and at least 3 °C above the dew point of the air, measured in the vicinity of the substrate. Good ventilation is usually required in confined areas to ensure proper drying. The moisture content in the substrate should not exceed 4 % (by weight). The coating should not be exposed to oil, chemicals or mechanical stress until fully cured.


Drying times :

Drying times are generally related to air circulation, temperature, film thickness and number of coats, and will be affected correspondingly.

1.Recommended data given is, for recoating with the same generic type of paint.

2. In case of multi-coat application, drying times will be influenced by the number and sequence and by the total thickness of previous coats applied.

3. The surface should be dry and free from any contamination prior to the application of the subsequent coat.


The drying time is measured by stated values:

Relative Humidity (RH) 50 %
Substrate temperature 10 °C 23 °C

40 °C

Surface (touch) dry 10h 5h 3h
Hard dry 30h 15h 9h
Dry to overcoat, minimum 30h 15h 9h


Substrate :

Cement plaster, Concrete, block work, rendered surfaces, Gypsum board, Wood, Steel etc.

Substrate should have sufficient strength to receive the paint. Any defects in the substrate like surface undulations, cracks, pin holes etc., should be rectified/filled before starting painting.


Surface preparation :

The substrate must be sound, clean, dry and free from dust, oil, grease, laitance etc. All traces of form release agents/curing agents must be removed. A light sanding with suitable abrasive material is recommended before application. Any resulting dust/loose particles must be removed.

JFPCEMW
2 Items

16 other products in the same category:

Product added to compare.