The product can be applied by:

Roller Recommended.
Spray: Use airless spray or conventional spray.
Brush: Recommended to paint corners and edges.

Conditions during application:

The temperature of the substrate should be a minimum of 10 °C and at least 3 °C above the dew point of the air, measured in the vicinity of the substrate. Good ventilation is usually required in confined areas to ensure proper drying.


Drying times:

Drying times are generally related to air circulation, temperature, film thickness, and the number of coats, and will be affected correspondingly.

1. Recommended data given is, for re-coating with the same generic type of paint.

2. In the case of multi-coat application, drying times will be influenced by the number and sequence and by the total thickness of previous coats applied.

3. The surface should be dry and free from any contamination prior to the application of the subsequent coat.


The drying time is measured by stated values:

Relative Humidity (RH) 50 %
Substrate temperature 10 °C 23 °C

40 °C

Surface (touch) dry 6h 3h 1h
Hard dry 10h 5h 3h
Dry to overcoat, minimum 8h 4h 2h



Cement plaster, concrete, block work, gypsum board, etc.

The substrate should have sufficient strength to receive the paint. Any defects in the substrate like surface undulations, cracks, pin holes, etc., should be rectified/filled before starting painting.

Directions for use

Surface Preparation

The substrate must be sound, clean, dry, and free from dust, oil, grease, laitance, etc. All traces of form release agents/curing agents must be removed. A light sanding with suitable abrasive material is recommended before application. Any resulting dust/loose particles must be removed.

Recommended Paint System:

PVA Primer (1 Coat) + Stucco (2 Coats) + Fenomastic series or recommended paint system (2 Coats)

14 Items


Jotun PVA Primer Data Sheet TDS

Technical Data Sheet (TDS) for Jotun PVA Primer

Download (79.4KB)

You might also like

16 other products in the same category:

Product added to compare.